Crosspost: Advise and datasheets needed

First of all, i'm sorry because of crossposting. I didn't know on wich groups to post this question so sorry. Second sorry on bad english.

Hi everyone.. i bought few steppers so i need datasheets or more information for them. Thanks

#1

5 phase stepping motor A3851-9215 DC 1.3 A 1.4 ohms/phase
0.72 deg / step FH7-1804 vexta, oriental motors
5 wires - black, green, yellow (orange?), red, blue.. Is this motor compatible for any CNC use?

#2 Type KH56Jm2U014 no 3408 japan servo co., ltd

6 wires, black, red, brown, yellow, blue, orange.. Is this motor compatible for any CNC use?

#3 Vexta model C6957-9015K,

5 phase, 0.72 deg/step DC 1.5A, 0.73 ohm, VS7 69368, oriental motors
5 wires - black, green, yellow (orange?), red, blue.. Is this motor compatible for any CNC use?

#4 Minebea, p/n EM-181 type 17PM-H005-P2V

6 pins on connector..

Can i use these motors in combination with this driver and PC PSU for 12V input?

Thanks again!!