Latest threads in Electronics Designshow only best voted threads

Subject Author Posted Replies
 
Magnet wire for fuse
Just found a bad surface mount fuse in a TV and of course, don't have the part. It's rated 60v at 10a. But -- I do have a real variety of magnet wire, some pretty thin stuff also. Wonder what guage...
34
34
 
The truth about the Moon Landing at last
10
10
 
Confusion
I have to design SCADA system for dam.I have water level sensor which has o utput between 4 and 20 mA in analog form and it is transferred to control r oom about 2 to 3 km apart from dam using OFC. Is...
9
9
 
Tek ads
On all sorts of web sites that I visit, I get the same "Overachiever" ad for the Tek DPO2000B series of oscilloscopes, sometimes multiple places on the same page. I must have googled it once, and I...
66
66
 
Tuning PDF loop (pseudo derivative feedback)
I know about the auto-tuning algorithm for PID: cycle the temperature up an d down, measure the peaks and distance between the peaks, and calculate Kp, Ki, and Kd. But recently I've been experimenting...
42
42
 
A $3.2 billion* thermostat....
Something is not right. Obviously a thermostat cannot cost a tiny fraction of that, nor do they have a market share worth anything like it. Not that I have much hope we will ever know what is going...
67
67
 
Circuit Board Aggregators
I have used the PCB aggregator that was run by SparkFun electronics in the past, and was pleased with them. I just got boards back from my very first order to OshPark, and I'm kind of underwhelmed....
8
8
 
manufacturer of inverter In china
Now as a leading professional manufacturer of power inverter and solar controler, We specialize in producing high quality DC to AC Inverter,sine wave inverter,power inverter,china inverter, vehicle...
 
lots of schottky diodes in a package
I'm going to have 48 signal lines that I want to clamp to a 1.5 volt bus, with a low-capacitance back-to-back schottky pair. A 3-pin dual schottky diode does one line. A 4-pin schottky bridge or ring...
23
23
 
OT: Refuse to copy file - AVAST is rootkit
> ** SNIPped previous stuff ** >> Since i am having a VERY repeatable problem with that FA930-C program >> set,what i could try is: (a) UNPLUG the EtherNet cable - making external >> attacks and...
4
4
 
Si contact I-V
Hi all, So I?m trying to make contacts with indium to a hunk of Silicon that I have. Seemed OK Resistance between contacts of ~400 ohms. I then did the I-V, Signal generator (100Hz) to audio...
7
7
 
Where is the gain?
Where is the gain? ...Jim Thompson -- | James E.Thompson | mens | | Analog Innovations | et | | Analog/Mixed-Signal ASIC's and Discrete Systems | manus | | San Tan Valley, AZ 85142 Skype: Contacts...
28
28
 
Tektronix DM2510 Digital Multimeter roms
Hi, I found one of such multimeter but the eprom 27c256 is gone (reads all 00s) does anyone have a rom image (the eprom label is: U212 DMM). The multimeter logic board have the space for the...
1
1
 
LDO failure modes?
Hi, I had a 7 port USB2 hub (DUB-H7, legacy version) give up the ghost, here. Always wanting to know "why", I pulled it apart. Of course, as with most low cost consumer kit, very little inside! All...
17
17
 
Absurdly Dangerous Militarization of America's Police
The Absurdly Dangerous Militarization of America's Police By Jim Hightower, Other Words 09 January 2014 Police departments across the U.S. have a growing collection of toys used by the army. What a...
42
42