Electronics Computer-Aided Design

  1. Home
  2. Electronics Computer-Aided Design
1796 Threads Posts
to

Worth reading in Electronics Computer-Aided Design

Micro-Cap 8 - any opinions?

Hi, Are there any technical reasons why Micro-Cap 8 shouldn't be bought as a direct replacement for PSpice? Most of us...
5 comments posted 22yrs
posted by a
5 comments posted 22yrs posted by a

Q:limits of spice simulation

Hello, where can I find some infos about some limits of spice simulation? I need it for a comparision of different simu...
9 comments posted 22yrs
posted by michi
9 comments posted 22yrs posted by michi

Problem with .step in LTSpice

Hi, I've come across an odd problem in the simplified circuit I'm posting to a.b.s.e under the same subject title as th...
3 comments posted 22yrs
posted by pb
3 comments posted 22yrs posted by pb

package parasitic models for Spice

Hi all, For multi-gigahertz analysis, a regular Spice model of the chip/die properties alone is of little use. You need...
6 comments posted 22yrs
posted by pb
6 comments posted 22yrs posted by pb

OT: Render External USB Harddrive As Non-Bootable

I removed the hard drive from the dead machine and installed it into a USB adapter.... it's reading just fine. However,...
19 comments posted 22yrs
posted by thegreatone
19 comments posted 22yrs posted by thegreatone

SPICE model for Agilent 77 package

Hi, Does anybody have a SPICE model for the Agilent "77 package"? It is a ceramic, surface-mountable package used for H...
0 comments posted 22yrs
posted by no.body
0 comments posted 22yrs posted by no.body

LTspice under wine

When i install LTspice under wine it doesn't complete the installation and gives me this error: Couldn't find startup Sh...
1 comments posted 22yrs
posted by jackgroups
1 comments posted 22yrs posted by jackgroups

VLSI group

Someone can tell me if there is a group specifically dedicated to all questions about VLSI systems, from architecture to...
0 comments posted 22yrs
posted by jackgroups
0 comments posted 22yrs posted by jackgroups

Orcad Layout

HI every1, Iam designig a PCB using orcad(9). At the moment i have two boards(each is a two layer board). I have almost...
2 comments posted 22yrs
posted by tazizi
2 comments posted 22yrs posted by tazizi

Protel DXP

Anyone know how to load a netlist into a blank pcb?
3 comments posted 22yrs
posted by ms
3 comments posted 22yrs posted by ms

ic Design

I've been trying to look up IC design and can't quite find what i'm looking for. I want to know what the shapes look li...
8 comments posted 22yrs
posted by dast7777
8 comments posted 22yrs posted by dast7777

ProtelDXP Off sheet Warning

Hi! does anyone know what OFF SHEET AT ... in protel DXP mean ? I want to solve this problem. Thanks
1 comments posted 22yrs
posted by michelebergo
1 comments posted 22yrs posted by michelebergo

Specctra Autoruter unplated through hole

Hi I'm using Cadint to design and Specctra 9.0 to auto-route. My problem: Specctra think all holes are plated, even tho...
3 comments posted 22yrs
posted by ne-nospam7
3 comments posted 22yrs posted by ne-nospam7

BFG194 info needed

Hi guys, Anyone got a spice model, datasheet or both for the BFG194? Thanks, p.
2 comments posted 22yrs
posted by pb
2 comments posted 22yrs posted by pb