Electronics Down Under

  1. Home
  2. Electronics Down Under
5133 Threads Posts
to

LCD module on sale

Dear Madam/Sir: Glad to know you through the Internet! Are you in need of LCD products? SEAKO ELECTRONIC CO., LTD (HUAX...
0 comments posted 20yrs
posted by sophie_seako
0 comments posted 20yrs posted by sophie_seako

Creepage distance of mains transformers AS 3108

Does anyone know off hand the isolation distance between primary and secondary on a EI tranny? i thought it was somethin...
13 comments posted 20yrs
posted by notinterestedin
13 comments posted 20yrs posted by notinterestedin

Behringer Circuit.

Hi, Does anyone know where I could get a circuit diagram for a Behringer B2031 amplified speaker. Thanks John Ely.
2 comments posted 20yrs
posted by zamiac
2 comments posted 20yrs posted by zamiac

Re: 60 Minute Soldering Iron Timer

"Peter Howard" > > I was talking about this 50 volt soldering iron timer project > September/October 2005 ** Yawn ........
0 comments posted 20yrs
posted by philallison
0 comments posted 20yrs posted by philallison

60 Minute Soldering Iron Timer

I was talking about this 50 volt soldering iron timer project September/October 2005 and now have four test prototypes...
2 comments posted 20yrs
posted by bbrover109
2 comments posted 20yrs posted by bbrover109

About Radio transmission link

Dear All, I am building up a radio transmission link with 4 bits digital input signal(around 50-100Hz). I have got two...
4 comments posted 20yrs
posted by send_to_lok
4 comments posted 20yrs posted by send_to_lok

Current sensing?

I need to sense the operation of a couple of pumps in the 1 to 2kW range. Measuring the actual current would be nice, b...
8 comments posted 20yrs
posted by pox
8 comments posted 20yrs posted by pox

XRays and electronics

Simple question. Will xrays damage electronics? Say if I was to xray the circuit in my car key? Thanks, Mike
22 comments posted 20yrs
posted by nospam
22 comments posted 20yrs posted by nospam

ABC editor "PROG Delay" question

I am using a "Hot chip"/"ABC mini" with Atmel AVR AT90S8535 and I am using ABC editor to connect to pc with parallel po...
7 comments posted 20yrs
posted by ljk
7 comments posted 20yrs posted by ljk

Re: ~SOME PIECE OF THOUGHT FROM A TRUE GEOLOGIST~

> >> Sir Jean-Paul Turcaud wrote: >> > Mates, >> > >> > Water Okay ! >> > >> >> Well, it didn't take Le Turd long to re...
2 comments posted 20yrs
posted by someone
2 comments posted 20yrs posted by someone

DSE Set Top Box: G7659

Hi to my pals here, In October 2005 I bought myself a DSE G7659 STB. It worked like a charm for 17 months or so. Then,...
5 comments posted 20yrs
posted by philallison
5 comments posted 20yrs posted by philallison

Interesting effect from Remote Control Extender

Folks, Thought I might share this weird effect I got from a Remote Control Extender unit, bought from Jaycar some 6 yea...
7 comments posted 20yrs
posted by someone
7 comments posted 20yrs posted by someone

Nylon screws

Hi all, Looking for a nylon screw, have a diameter measurement of 5mm and is that a M5? Thanks in advance eltan
7 comments posted 20yrs
posted by eltan
7 comments posted 20yrs posted by eltan