Latest threads in Raspberry Pi Groupshow only best voted threads
Subject | Author | Posted | Replies | |
---|---|---|---|---|
|
Upside-down maps in chromium
After observing upside-down maps in chromium for some months a fix was presented in: The fix is to run chromium from a command line, so: MESA_EXTENSION_OVERRIDE=-GL_MESA_framebuffer_flip_y...
15
|
3 years ago
|
15 | |
|
Amule with Raspberry
I tried to install amule on the raspberry: the amuleweb service, however, does not start automatically but I have to launch them from the shell. Another problem I also have to change the port because...
16
|
3 years ago
|
16 | |
|
Strange construct in BASH script file
I am NOT a BASH expert by any stretch of the word, so I may have my ignorance to blame on this. I picked up a script for the Raspberry Pi that will, when run, give you a report about all sortd of...
32
|
3 years ago
|
32 | |
|
HC-05 module on a JY-MCU breakout board - what and how is it buffered ?
Hello all, I've bought myself a HC-05 module on a JY-MCU breakout board, but cannot seem to find anything concrete about what the JY-MCU breakout board (stamped ZS-040) does or needs. The pinning:...
30
|
3 years ago
|
30 | |
|
Talking to u-boot on Buster
When booting Buster on a Pi3B+ it seems that u-boot finishes before there's any chance of text input on the console. How does one make u-boot pause and accept input so the boot can be redirected from...
4
|
3 years ago
|
4 | |
|
Error during upgrade.....any ideas?
While upgrading Raspbian OS on a Pi3 apt-get upgrade reported: Error: Unit -.mount is masked. I've never seen this error before, does anybody know what's going on? Thanks for reading, bob prohaska
6
|
3 years ago
|
6 | |
|
Extracting SDcard image from Zip archive for writing to microSDcard.
Re: Extracting SDcard image from Zip archive for writing to microSDcard. By: Henri Derksen to All on Mon Jun 29 2020 02:42 am HD> So the question is, "How can I extract and write that image to the HD>...
2
|
3 years ago
|
2 | |
|
BMP180 Barometric pressure sensor - deviates about 8 full points from expected
Hello all, I've bought a BMP180 barometric pressure sensor and used an existing implementation of the conversion formule (as in the PDF mentioned below) to see it work. The problem is that the air...
22
|
3 years ago
|
22 | |
|
Using an RPi 3B+ as a "post office" between two subnets ?
Hello all, I've got a few computers in seperate subnets which I do not allow to communicate with each other. When I need to transfer data between computers in those subnets I use an USB stick. Somehow...
111
|
3 years ago
|
111 | |
|
BMP180 barometric sensor (I2C) not detected.
Hello all, I've bought myself a BMP180 sensor exactly like shown here : The problem is that my RPi, using "i2cdetect -y 1" doesn't seem to detect it. The RTC connected at the same time does show up...
5
|
3 years ago
|
5 | |
|
Identifying UASP compliant adapters
Having fumbled my first attempt to get a "good" usb-sata adapter for eventual use with a Pi4 it's time to ask again for advice. Very few usb3-sata adapters disclose enough information to ascertain...
20
|
3 years ago
|
20 | |
|
Pi1 to Pi3B+ Vulkan driver running VkQuake III at 100 FPS+
Just passing along this great news. Linux Hardware Reviews & Performance Benchmarks, Open-Source News - Phoronix
—
|
3 years ago
|
— | |
|
Pi 4 and USB C
Hello, I have a short question and I hope you can help: as I understand it the first release of the Pi 4 had issues with the USB-C port. Has that been fixed and a new hardware revision is released and...
63
|
3 years ago
|
63 | |
|
Re: Raspberry Pi2 and BME280 Sensor problem
In message , David Taylor writes Thanks. I've not got any PI1s so I've not been able to test that. The legend on the graphs refers to "RaspI-3", I'm assuming that is the host name of the Pi. It can be...
1
|
3 years ago
|
1 | |
|
Rpi4 with debian buster - no audio
I am running the debian buster from nfs root with the RPi 4 4.19.97-v7l+ #1294 kernel However I can't get audio working neither on the 3.5" jack nor on the HDMI With raspbian I got sound at least...
2
|
3 years ago
|
2 |