Raspberry Pi Group - Main Page

Do you have a question? Post it now! No Registration Necessary

Raspberry Pi Group Discussions about Raspberry Pi single-board computer
Web, RSS and Social Media interface to comp.sys.raspberry-pi
There are 20122 individual articles here that are part of 1167 discussions
Please see below the list of the most recent and the best rated articles in Raspberry Pi Group

The most recent discussions

Headphone vs HDMI audio


August 22, 2019, 5:54 pm

Has anybody noticed a material difference in audio quality between the headphone jack and what comes out of the HDMI port? Obviously, a display with a poor audio circuit can corrupt a good signal... Read more »

YT: Cheap Crimpers: IWISS IWS-2820M against Engineer PA-09?


August 20, 2019, 9:29 am

Cheap or Expensive https://www.youtube.com/watch?v=25qObkSUHng Doesn't chip hair or 13 Amp ring main, this is for mini-crimps, as used in the maker community. R-Pi etc.... https://en.wikipedia.o... Read more »

problems creating wlan0 device


August 20, 2019, 9:02 am

On a new installation on a old raspberry (the very first version) There is no wlan device, even after inserting a usb wifi device. Ifconfig shows only eth0 en lo. How to create the device? Should... Read more »

Wireless internet router ..

  [ 2 3 ]
August 16, 2019, 10:37 pm

I would like to share mobile internet to ethernet devices and was thinking if that would be something one can do with rpi? Any examples around? Thanks! Read more »

Latest system updates!


August 12, 2019, 4:35 am

Hello All! Since I updated the box with the current-ish set of updates I have lost screen output - screen says no connection. Have no issue logging in via ssh but would like to use the gui for som... Read more »

Solved: Laser-Faxmachine / All-in-one?


August 11, 2019, 9:43 am

Hi everyone, please allow me to share my experiences with All in one Fax-devices here. After a really exciting and informative discussion about what to buy and how to use, I finally got a ... Read more »

ModMyPi bought by ThePiHut (ref. pico ups)


August 8, 2019, 12:46 pm

Just noticed that ModMyPi's URLs redirect and, sure enough, found a report from 20 June that ThePiHut has acquired their stuff. https://www.recantha.co.uk/blog/?p=19515 That may be a shame, de... Read more »

Airspy USB on Raspberry Pi model 2B, doesn't work in Buster?

  [ 2 ]
August 8, 2019, 5:06 am

I've been using the Airspy ADS-B decoder on a model 2B with an early OS (Jessie?) for some time, without problems. The software is described here: https://airspy.com/quickstart/ => Using the ... Read more »

Pi4 i/o layout


August 8, 2019, 1:40 am

What is the I/O setup on the new Pi4? Is it like the earlier Pi2/Pi3, with a single usb hub supporting all traffic? I gather it has a usb3 port, but it's unclear what upstream bottlenecks might be... Read more »

GPIO problem


August 6, 2019, 7:17 pm

I've been running a PI3 with a rain gauge attached for a few months now, and all seemed to be fine. However a few days back, it started going mad. I now appear to be getting something like 0.66 ... Read more »

Click here for other recent discussions »

The best rated discussions

rating
5

Raspberry Pi ZeroW as a WiFi Router

  [ 2 ]

Has anyone used a Raspberry Pi ZeroW (or another Pi, plus a USB WiFi adapter) as a WiFi router? As my existing WiFi router already connects to the internet using a USB mobile broadband modem, this... Read more »

rating
5

64 bit OS

  [ 2 3 4 5 ]

Which 64 bit OS is recommended for the Pi3, for I cannot locate such on the wiki? Perhaps NOOBS runs in the 64bit manner but in the AArch32 option? Read more »

rating
5

Controlling HD44780 as a character device?

  [ 2 ]

Hello, beeing a Linux guy for nearly two decades now, I wonder why all the suggestions for controlling a HD44780 from a Raspberry Pi will use direct GPIO (or I2C) access from userland? Despite th... Read more »

rating
5

Best way to share between two raspberry pi's


I got the setup off more then one rpi's 1. My media player runs on openELEC 2. Raspbian Wheezy (debian) my download center So that's my setup Now I want from rpi2 to write on a usb drive on rpi1.... Read more »