I recently got an umax scanner that was going to trash. The stepper motor controller chip seems to have burnt. It's a TI, but that's quite all I know about the reference. I mailed the umax support, but got no reply, I don't think they care that much. Anyone has an umax astra 2000P (maybe other refs have the same board) and could tell me the IC ref of U3 on the main board marked: HAIO M/B 2000P (+SHUTTLE) REV:B P/No: 5100011-0003 9913
Cheers,
____________ here are numbers of chips I found on *MY* M/B:
[1] EK9840V; TCC099916 [2] UT51C164JC-35; 9934 [3] 130 100 56; -5011; 9936E [4] H E; 7805; 9ER A [5] LB1233; 8S6the number of cable is:
[1] FUJIKURA-R; RU AWM; 2896; 80C; VW-1there are, in UMAX ASTRA 2000P (P=Parallel port), total 3 printed circuits, should I write You the number of chips located on the othe
2?I am interesting in materials about UMAX ASTRA 2000P. [: Could You send me, if You have some, please? :]
mar vrba (xxxxx0{at}centrum{dot}cz)
P.S.: But the id of *MY* M/B differs a bit, it is: HAIO M/B 2000P (+SHUTTLE) REV:C P/NO:510 000 11-000
-- mar vrba
Hi. Greetings from India. I don't know if my reply is relevant at this time but I Have the same board here with me except that the last numbers are 0004 9021 Pz let me know if you need this. I reckon it is in working condition as it was working last time I had used it.
Pz note I hv the said board with me very possibly in working cndn.REV:C P NO:51000011-0004 9021. Pz mail if req... Thank you
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.