Is there a way to adjust the picture to eliminate the curve at the left and to bring the right into the 27" screen area. Only 1 digit of the channel is visible on the right side of the screen.
It gives a really nice clear picture.
Thanks,
Is there a way to adjust the picture to eliminate the curve at the left and to bring the right into the 27" screen area. Only 1 digit of the channel is visible on the right side of the screen.
It gives a really nice clear picture.
Thanks,
Whats the Model Number.
Model # F27650 TX2
Thanks.
I don't know if that's a CTC203 or ATC113 anyhow you have a Pin Fault best take it in to get serviced before its gets any worse...and it will.
kip
Kip, I am inpressed!
(My Father-in-Law was a TV repairman in Tarrytown, N.Y.
I wish that he was still with us. A nice guy.
We used to take a few trade-in sets apart to make a good one.
That was fun.)
The chassis # is: ATC113BB1.
What is a Pin Fault?
What is the repair?
Is it a R&R?
Thanks!
Its nothing you can do but take it in...sooner the better. I doubt you have the equipment to pin point the fault.
kip
"Pin" point? :-)
Tom
Yeah, pccpoint wouldn't have been nearly as clever!
John
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.