Panasonic NVSD240 VCR problem

I have a Panasonic NVSD240 that plays tapes perfectly well with brilliant picture. However, when powered on and before inserting a tape, it shows 'no signal' (no blue screen or similar as other VCRs - TV says 'no signal'). Also it does not respond to its original remote control. The remote itself is fully functional and I tested every button in it with an IR detector. Consequently the clock display keeps flashing 0:00 and I am unable to set the time or access the VCR menu as all of these functions require the remote, with no alternative buttons on the VCR itself. The connection to TV is via SCART (this UK model has no video out RCAs). To reiterate, there is excellent picture when tape plays. Just 'no signal' when tape is stopped and no VCR menu. No response to remote either. Can you help? Much thanks!!

--------------= Posted using GrabIt =----------------

------= Binary Usenet downloading made easy =---------

-= Get GrabIt for free from

formatting link
=-

Reply to
Joe
Loading thread data ...

The remote receiver module is almost certainly bad (it happens). Wouldn't hurt to confirm it's solder connections are OK, though.

A technician can check the functional status of the module using a multimeter and an oscilloscope.

On an older model, Panasonic very possibly won't have the part available any more. There are many types of IR receivers and they are generally NOT interchangeable. If one gets lucky an identical part can sometimes be found in some other unit, for example a "scrapper" that a repair shop might have laying around.

Mark Z.

Reply to
Mark Zacharias

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.