Lamp with batteries

Hi all

I have a lamp I use for camping. Accidently it was left with the batteries in for the winter, and they have leaked a bit. I have repaired cases like this before, usually with a file and sand paper, then added some solder on it. But do you have any better suggestions?

WBR Sonnich

Reply to
sonnichjensen
Loading thread data ...

I've wandered across gear with leaked batteries a number of times in my life... What I do these days is to disassemble, go over what I can wash in water and what I can't. What I can't wash in water I go over with an old toothbrush (tho an ESD brush should be safer) and IPA (Isopropyl alcohol) or IPA wipes (or denatured ethanol) taking off any residue I can get off.

The rest I use a dedicated dish brush and your garden variety washing up liquid on, as well as hot water as my hands can bear. Haven't run across things leaked to such an extent that solders have to be redone or reflowed.

As to tougher spots of electrolyte, I've recently come across videos of using white vinegar (acetic acid), pickling grade to remove corrosion, I wonder if it could work on tough crusts of electrolyte?

/Teo.

--
teostupiditydor@algonet.se | for you are good and crunchy with 
Remove stupidity to reply  | ketchup.
 Click to see the full signature
Reply to
Teodor V.

ies in for the winter, and they have leaked a bit.

per, then added some solder on it.

,

Yes, vinegar and/or baking soda, depending on the nature of the leaked elec trolyte. If possible, the dishwasher as preferred cleaning method top rack, and only those machines without an exposed heating element inside. That wi ll remove any salts and loose corrosion.

Peter Wieck Melrose Park, PA

Reply to
pfjw

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.