Hi supertechs,
I have a laptop mobo that has blown a power MOSFET feeding the 1.5V to the processor. I need to replace it, but I am hesitating as to what tool to choose for the job. The board has components on both sides and overheating the MOSFET can desolder small components on the back of the board. The back of the MOSFET is soldered to the motherboard for better heat transfer. Any suggestions?
Cut the 'legs' off first and remove them individually. This means little heat is transferred to the pcb.
Removing the 'body' will be trickier but at least with the legs gone, it'll be easier.
Graham
I would recommend you have someone who has done this before do it.
A laptop mainboard is not the place to be practicing your solder skills!
--- sam | Sci.Electronics.Repair FAQ:
Important: Anything sent to the email address in the message header above is ignored unless my full name AND either lasers or electronics is included in the subject line. Or, you can contact me via the Feedback Form in the FAQs.
You will need a fairly high wattage soldering iron like a Weller which can supply quite a high temperature for a short period of time.
The other option is to de-solder each pin and then wait a few minutes to allow the component and board to cool before working on the next pin.
-- M.Joshi
I did this on a desktop mobo following the clip and unsolder ideas mentioned by others. I could not reattach as the original and the MOSFET stood off, looked ugly but worked. The laptop you may not have sufficient room for an "ugly" job.
-- Remove -NOSPAM- to contact me.
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.