hello, I have a viewsoni N2700w LCD. The power cable that runs from the VISIONBANK board to power the LCD panel shorted out because the protective sheath was touching some metal on the inside of the case. I have linked some pictures of the problem, and if I was able to get a replacement power cable, everything would work fine. Is there a place i can obtain this cable, or what do i need to do in order to make the cable myself?
Could i just cut off the melted 4-pin connector and solder the cables right to the 4 pins?
I've included pictures of the unit before I took out the cable that's been burnt, and an image of the cable by itself.
Thanks for any help!