Do you have a question? Post it now! No Registration Necessary
Subject
- Posted on
Bootloader 908AZ60A
- 01-23-2006

Re: Bootloader 908AZ60A

P&E Microcomputer Systems (http://www.pemicro.com /) has a free
programmer and in-circuit debugger for HC908 MCUs. The software works
best with a full-blown MON08 interface and P&E's Mutlilink cable, but
I've used the software with half a MAX232, three resistors and two
diodes. See Freescale's AN2317 "Low-Cost Programming and Debugging
Options for M68HC08 MCUs." This application note describes building the
interface and configuring P&E's software to talk to what you've built.
I used the design in figure 5 with a 68HC908GP32 and it worked like a
champ.
NM

Re: Bootloader 908AZ60A
I used it myself but would like to program it without the programmer. I need
the pins for my application and don't want to use jumpers etc. I have
translated a gp32 bootloader into a ab32 but just wondered if there was a
plug and play version for the az60.
thanks any how...
SFC

Site Timeline
- » AVR JTAG programmer choice
- — Next thread in » Microcontroller Discussions
-
- » pic -> sed1530 lcd asm code?
- — Previous thread in » Microcontroller Discussions
-
- » Soft-UART, a different approach
- — Newest thread in » Microcontroller Discussions
-
- » stampante termica gebe flash 4378
- — The site's Newest Thread. Posted in » Electronics Hobby (Italian)
-
- » Ceramic capacitor failure
- — The site's Last Updated Thread. Posted in » Embedded Programming
-