Hi
I need a replacement number, but at 20 amp, for my fast rectifier STPR166 , my rectifier are a 200 volt 16 amp. but I need a rectifier 200 volt 20 amp. or 25 amp.
Any suggestions rectifier (200 v 20 amp) ?
Here's the complete spec of my actual rectifier that I need to replace.
-----
LITE-ON SEMICONDUCTOR
STPR1660CT
----------
SUPER FAST REVERSE VOLTAGE - 100 to 600 Volts GLASS PASSIVATED RECTIFIERS FORWARD CURRENT - 16 Amperes
TO-220AB FEATURES Glass passivated chip Superfast switching time for high eficiency BLTO-220AB M Low forward voltage drop and high curent capability DIM. MIN.MAX. C Low reverse leakage curent DA14.215.8 B 9.6510.67 High surge capacity KA C 2.54 3.43 Plastic package has UL flammability clasification 94V-0 E PIN D 5.84 6.86
123E 8.269.28 FF - 6.35 G12.7014.73 MECHANICAL DATA GH 2.29 2.79 Case :TO-220AB molded plasticII 0.51 1.14 J Polarity: As marked on the body J 0.30 0.64 NK 3.53 4.09 Weight:0.08 ounces, 2.24 grams H HL 3.56 4.83 Mounting position : Any M 1.14 1.40 PIN 1 PIN 2N 2.03 2.92 PIN 3 CASE Al Dimensions in milimeterMAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 ? ambient temperature unless otherwise specified. Single phase, half wave,60Hz, resistive or inductive load. For capacitive load,derate curent by 20%
STPR STPR STPR CHARACTERISTICS SYMBOL STPR STPR STPR UNIT
1610CT1620CT1630CT1640CT1650CT1660CT Maximum Recurent Peak Reverse Voltage VRM 100 20 300 400 500 600V Maximum RMS Voltage VRMS 70 140 210 280 350 420V Maximum DCB locking Voltage VDC 10 20 300 400 500 600V Maximum Average Forward I(AV) Rectified Curent@TC=120?16A Non Repetitive Peak Forward Surge Curent Per Diode IFSMA Sinusoidal(JEDECMethod)TP=8.3ms90Maximum forward Voltage IF=8A @TJ=25?1.11.31.5 Pulse Width=300usIF=8A @TJ=125?1.01.2 V1.4 FV Dutycycle IF=16A@TJ=25?1.251.51.7 IF=16A@TJ=125?1.201.41.6
Maximum DC Reverse Curent@TJ=25?I10 RuA at Rated DC Blocking Voltage@TJ=10?50 Typical Junction Capacitance CJ80pF perelement(Note1)
Maximum Reverse Recovery Time (Note 2)TRR303550ns Typical Thermal Resistance R?JC3.0?/W
Operating and Storage Temperature Range-5 to +150? TJ,TSTG
NOTES :1.Measured at 1.0MHz and aplied reverse voltage of 4.0VDC.REV.0, Dec-203,KTGC12 2.Reverse Recovery Test Conditions:IF=0.5A,IR=1.0A,IR=0.25A.
-----
Thank
Gaetan