anybody knows something about this? i got a good 7812 power supply with big capacitors and some small mkm , and pin 2 connected to + with a 10k resistor wich improved a lot,but not all of the error triggers.
thanks.abe
anybody knows something about this? i got a good 7812 power supply with big capacitors and some small mkm , and pin 2 connected to + with a 10k resistor wich improved a lot,but not all of the error triggers.
thanks.abe
-- remove x in mail adress to reply
all
I would suggest bypass caps from the Vcc pin to ground; 0.1uF ceramic, and
10uF tantalum should help.Also, make sure the control input is bypassed to ground using a 0.1uF cap.
Regards, Bob Monsen
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.