XMD only operating in compatibility mode under Suse9.2 pro

Hi,

I follow the steps from

formatting link

Environment: Suse9.2 (Kernel 2.6.8-24) ISE6.3.03i EDK6.3.02i Impact6.3.03i

When I try load xpc4drvr module, the kernel message shows following message xpc4drv: unsupported module, tainting kernel. xpc4drvr: init_module

I tried reload the module again, same message appear again. I am sure that xpc4drvr module is loaded on the module list. However that xmd show that it can't find the module and operating in compatibility mode instead of high speed mode. Is anyone knows how to fix this problem?

Partial Message log: AutoDetecting cable. Please wait. Connecting to cable (Parallel Port - parport0). WinDriver v6.23 Jungo (c) 1997 - 2004 Build Date: Nov 17 2004 X86 11:07:13. parport0: baseAddress=0x378, ecpAddress=0x778 LPT base address = 0378h. ECP base address = 0778h. ECP hardware is detected. Cable connection established. Connecting to cable (Parallel Port - parport0) in ECP mode. Module xpc4drvr is not loaded. Cable connection failed. Connecting to cable (Parallel Port - parport0). WinDriver v6.23 Jungo (c) 1997 - 2004 Build Date: Nov 17 2004 X86 11:07:13. LPT base address = 0378h. ECP base address = 0778h. Cable connection established. ECP port test failed. Using download cable in compatibility mode.

Thanks in advance.

Jason