Virtex2 simulation madness

Hi everyone,

I have been trying to get a good behavioral simulation going of a Virtex2 on the ML310 board. I'm trying to simulate a standard generated chip architecture with DSOCM & ISOCM running the standard generated test-program.

As far as I know there are two ways to go (with the software I have):

1) directly from XPS 2) via ProjectNavigator

The problem with 1) is that the simulated chip "hangs", it does not run any program, and all the core reset signals go high, and never come down... (I provide stimuli to the pin_clk and pin_rst)

The problem with 2) is that I can't even get a proper simulation to work, when I run the sim from XPN, it tells me that the components aren't bound, resulting in Undefined signals everywhere but the RST and VCC.

I am new to these kind of large scale VHDL environments, so any help would be appreciated.

Jim Tuilman

Reply to
zoinks
Loading thread data ...

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.