Power PC ISOCM Simulation

I am simulating a system where I use the ISOCM and DSOCM for all code manipulation/data movement to/from the PowerPC. I have verified that the system_init.v file is poulated and pointing the DSOCM_Bram and the ISOCM_Bram. However, once the Power PC comes out of reset I see NO activity at all...on any Power PC interface.

The OCM controllers appear to have the correct register initialization values that should enable them coming out of reset.

The C code is very simple. I am wondering if I need to put some init sequence to get the Power PC up and running.

Reply to
motty
Loading thread data ...

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.