HP3455A offset/drift problems in 100+1000V DC range

Hi,

im currently troubleshooting a HP3455A for a annoying problem.

10V and smaller ranges all seem perfectly okay, as is ohms and AC voltage, while 100 and 1000V DC dont. Just after Power-Up the TEST mode gives me 7, 5 and 4 and readings in the 100v range are way off (too small), increasing to almost the proper value with every autocal click then drifting back quickly.With autocal disabled, the reading is drifting down quickly as well. After a short time, the error 7 disapperas and the behaviour gets a little better but still drifting badly and way out of spec readings. Trying to isolate the fault, i found that breathing at the area around R63 (active attenuator) is very sensitive and offset/drift gets way worse.Heatgunning this area resolves all errors and restores almost-in-spec performance. As soon as it cools down some hours, the problems all reappear. For parts, theres a 1855-0246 (no x-ref) dual JFET, a 10p 500v ceramic tube style cap and a 150p polystyrene (?) axial lead cap, all connected to a wire routed on teflon standoffs, among some 'standard' parts.

Is it common for JFETs to have leakage problems at low temperature? How to properly test the FET for leakage? Anyone got specs on that FET?

Now does anyone have previous experience with similar problems and maybe knows which parts are notorious to fail?

Regards, Robert

BTW:Im still looking for schematics for a Tek TAS220/250 scope...

Reply to
Robert Obermayer
Loading thread data ...

Use component cooler on each part.. when you find the one that really goes off the deep end, You've found the problem. Yes, FETS can go bad. But, you may have something as simple as a bad solder joint or, it could be a bad connection internally on one of the components. the chilling spray usually finds that.

--
"I'm never wrong, once i thought i was, but was mistaken"
Real Programmers Do things like this.
 Click to see the full signature
Reply to
Jamie

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.