Setup Code Composer Studio for TMS320F2808? (HELP)

How do I setup Code Composer Studio v2 to compile for the TMS320F2808?

And how do I setup my XDS510PP PLUS JTAG Scan Path Emulator to work with this DPS?

I suspect that I must download a lot of updates?

Reply to
Moppe
Loading thread data ...

Not necessarily.

Try runing the web update/update advisor from the help menu can't remember if that is in v2 or v3. It should show the main updates required.

First make sure CCSv2 supports the chip or chip family. If so then just make a new project for the chip family.

First run setup, load the gel file either for the board you have or the simulator you want to use with the correct endianness set for your application (I'm not fimiliar with the C2000 family only C6000)

For us v2 was quite flaky compared to v3 and v3.1.

Find the spectrum digital support page for the XDS510PP

formatting link
formatting link
then follow the setup guide/release notes.

Alex

Reply to
Alex Gibson

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.