Rabbit Stack Trace Overflow

I'm maintaining some code on a BL2600 board and recently saw an unhandled RST38 error while in debug mode. From what I found on the internet this normally means writing outside an array boundary or a stack overflow. I made a few changes to the code and the error went away but I wanted to check further to make sure there wasn't a problem.

I found that if I start my program from DynamicC 9.62 in debug mode and put a breakpoint somewhere, I can view the Debug Windows -> Stack Trace and see a few bytes written to the stack and everything looks OK. I can put the breakpoint somewhere else and see a different stack trace as expected.

If I just start the program and check the Debug Windows -> Stack Trace without using a breakpoint, I see 9008 bytes traced and Overflow - 4096 bytes allocated. The program does seem to work without any runtime errors. I would expect if the stack were overflowed by that amount I would be having major problems. I also implemented a Stack Limit Violation ISR to trap any overflow, it never fires.

Is the stack really overflowed by that amount, or does it show an overflow because I didn't put a breakpoint in to halt the program before checking the stack trace?

--------------------------------------- Posted through

formatting link

I think I have my answer. I implemented a Stack Limit Violation interrupt as suggested at the bottom of

formatting link

Forcing a stack overflow brings up the system error handler and shows the file name and line number that caused the overflow. Actually the line number was just the last line of the function where the overflow occurred.

I also implemented code from

formatting link

to fill the stack with 0xff at the start of main(). I periodically check the stack usage and print out the low water mark when it changes.

When I run my program, the Stack Limit Violation interrupt never fires unless I force a stack overflow. The check_stack function shows a low water mark for my program of 2994 bytes of 4096 unused in stack, nowhere near an overflow.

Using DynamicC's Debug Windows -> Stack Trace still shows 9008 bytes used and a stack overflow unless I set a breakpoint somewhere first. Then it shows the current stack usage which is usually something less than 16 bytes. I'm not too sure where the 9008 bytes came from but the Stack Trace is obviously not correct until a breakpoint is set first.

--------------------------------------- Posted through

formatting link