Hi All I'm new to embedded development.I'm supposed to work on LCD.After readin the data sheet,to power on the LCD some RSB pin in the LCD controller ha to set to low.Can anybody give idea of how to write the LCD driver wit some sample C code.Please help me out in solving this
Thanks
umm ok, what sort of LCD is it? what uC? what have you got working so far? have you got a schematic?
I'm confused. Do you think that *anyone* could help you without more information?
I need some money, so please send me a winning lottery ticket. I am desperately awaiting your assistance with this problem.
-- John B
I cannot send you the winning ticket, but I can help you with the numbers. I am pretty sure that it is some sort of combination of the numbers 0, 1, 2, 3, 4, 5, 6, 7, 8 and 9.
Anton
Thanks Anton, I knew I was going wrong somewhere.
011100101101101 just doesn't cut it with the lottery. ;-)-- John B
I have implemented a LCD driver on the Xilinx ML403 board using the MicroBlaze soft processor. You can read more in my blog:
Sven
That was goodOne ;-)
ali
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.