galvanic isolation for USB ?

Hi Does anybody know a solution for a galvanic isolated USB interface using an infineon C165UTAH ? Thank you Frank

Reply to
Frank Joachim
Loading thread data ...

What for? Isn't it simpler to isolate the part of the circuit that really needs to be isolated? Who cares if the USB side itself isn't?

Reply to
Guillaume

Maybe isolate only USB chip (like USBN.....) with 3 optron (RXD TXD CLK) is more simply that USB?

Reply to
artem

"Frank Joachim" wrote in news:bnoium$jj9$ snipped-for-privacy@nella.toplink-plannet.de:

If you're using a separate USB tranceiver (Philips makes them) then you can isolate between that and the USB controller using a magnetic isolator (high speed compared to opto) and bus-power the transceiver. This works for full speed. For high speed, you'd need to isolate a much wider bus so the isolation will be more expensive. I haven't tried that.

--
Kenneth Porter
http://www.sewingwitch.com/ken/
Reply to
Kenneth Porter

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.