I am using the AVRStudio4 to create .hex files, but I find that it is inserting code before the object I am trying to create. I used AVRStudio once before, but an earlier version and had great results programming with my current setup. However, the old version that worked has been lost. When I try to export, I have to use CVAVR and go into terminal mode. The files created by the new studio fail to complete a programming of a chip, and files created by the old system load fine. What I have found is that the new version inserts :020000020000FC at the beginning of every .hex file, and this makes my programmer puke. I presume the programmers Atmel intended to drive use this initial code to set up for some common purpose, which my programmer, a DIY K122, also from Atmel doesnt like it. Does anyone here know a setting in the new studio I need to set? I have looked at everything I can find. This is the freeware version, and is not supported by Atmel. TIA
- posted
19 years ago