cnc

- J
- Josip Almasi
  
  Contact options for registered users
posted
prije 9 godina

Thu, Jul 31, 2014 8:55 AM

A sta kazete za ovo?

formatting link

Pozdrav...

Loading thread data ...

- V
- vaso
  
  Contact options for registered users
Vote on answer
posted
prije 9 godina

Thu, Jul 31, 2014 1:38 PM

Zanimljiv koncept s dva motora po jednoj osi....

- J
- joss
  
  Contact options for registered users
Vote on answer
posted
prije 9 godina

Thu, Jul 31, 2014 7:51 PM

Odlican projekt. Hvala za link.

pozz

- F
- Filip Lolic
  
  Contact options for registered users
Vote on answer
posted
prije 9 godina

Fri, Aug 1, 2014 3:27 PM

Dva motora po jednoj osi je nesto sasvim uobicajeno u CNC svijetu ;) f

- K
- Kuki
  
  Contact options for registered users
Vote on answer
posted
prije 9 godina

Sat, Aug 2, 2014 6:03 AM

Dapace, ja sam i malo skeptican prema onima sa jednim motorom.

- V
- vaso
  
  Contact options for registered users
Vote on answer
posted
prije 9 godina

Sat, Aug 2, 2014 6:25 PM

- F
- Filip Lolic
  
  Contact options for registered users
Vote on answer
posted
prije 9 godina

Sun, Aug 3, 2014 8:03 AM

vodilice. Ni jedan ni drugi kompromis nemaju puno smisla. f

- V
- vaso
  
  Contact options for registered users
Vote on answer
posted
prije 9 godina

Mon, Aug 4, 2014 4:31 PM

A dvije vodilice i vreteno u SREDINI? Barem je upravljanje jednostavnije ( samo jedan motor),

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.