Rectangular ceramic power resistor in a Braun handheld blender (120 vac) is open.
Markings on resistor are: 206-8 R R47 10% *
(That's 10 percent followed by a dot, in case the symbol doesn't show up right on your computer...)
I did a Google on resistor markings and values, but got just traditional color codes, etc. The markings on this resistor are Euro designations, I presume.
What's the value of this resistor?
URL for future ref would be appreciated.
Thanks,
-- Please, no "Go Google this" replies. I wouldn't ask a question here if I hadn't done that already. DaveC me@privacy.net This is an invalid return address Please reply in the news group
R47 is almost certainly 47 ohms. Don't know how many watts, but match the physical size of it and you'll come close.
Ah! Of course! The R for the decimal point. Thanks.
The "R" is used sometimes as a decimal point (4R7 = 4.7 ohms) so R47 could be 0.47 ohms. Buy both, try first the one of 47 ohms.
-- Ing. Remberto Gomez-Meda http://ingemeda.tripod.com/ INGE - Ingenieria Electronica. Puerto Vallarta, Jalisco, Mexico.
On Sat, 21 Aug 2004 09:58:26 -0700, Peter A Forbes wrote (in article ):
but
Thank you, Peter, and all others. I'm on my way to buy a 0.47-ohm, 5W replacement.
Thanks again,
-- Please, no "Go Google this" replies. I wouldn't ask a question here if I hadn't done that already. DaveC me@privacy.net This is an invalid return address Please reply in the news group
Most certainly 0.47 ohms.
47000000 -> 47M 47000 -> 47k 47 -> 47R 4.7 -> 4R7 0.47 -> R47-- Göran Larsson http://www.mitt-eget.com/
47R certainly would be 47 Ohms. In the Euro style the R indicates the position of the decimal point, so R47 would more likely be 0.47 Ohms, in my humble opinion... dr
You are correct, we use 0R47 on our own schematics to reinforce the point, but R47 will be 0.47 ohms.
Peter
-- Peter & Rita Forbes snipped-for-privacy@easynet.co.uk Engine pages for preservation info:
DaveC schrieb:
Made by Vitrohm/Yageo, look here for datasheet:
Regards, Dieter
If that is the square ceramic cased types, they are a little bulky, but are slightly higher rated in W than equivalent wirewounds. The standard Vitreous enamelled 3W and 6W types are a close replacement as long as you don't need the slightly higher dissipation. The also do a solderable spike for them to allow vertical mounting with support, which can be useful to keep the heat off the PCB.
Peter
-- Peter & Rita Forbes snipped-for-privacy@easynet.co.uk Engine pages for preservation info:
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.