Hi.
Am planing to use one 5V or 9V stepper motor for driving one piston. The piston with some weight has around 200 grams and the slider is on rollers so there is no problem with "transmission".
Did some one of you used such setup or something similar ? Am asking this because am planning to use stepper from old epson printer.
Control will be set over arduino.
Gm
-------------- Here is some ready made solution:
Maybe this would to the trick ?
That would do it. Such pcb's are all over ebay.
use the stepper motor driver chip from the old printer.
-- umop apisdn
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.