I live in a high rise building that is about 30 years old. Unfortunately the 2 elevators which service my floor are completely retarded and seem to be completely un aware of each other as they sometimes will both open when called or not stop on floors or other obscure behavior.
In general this is not too big of a problem since eventually they do come to my floor and take me where i need to go. During peak travel times, however, I can wait for the elevator to get to my floor (out of
20) for as long as 5 minutes before it gets there.knowing this, i have even gone in the hallway, pressed the button, gone back inside, brushed my teeth, come back out, wait a minute and finally see it arrive.
being somewhat technically savvy and in need of a fun project- i would like to install a simple receiver inside the button panel in the hallway and have a small fob in the apt. ideally, i want to be able to "press" either the up or the down button from my apt so that i can call the elevator in advance before i get to the panel. i don't have too much interference- perhaps 40 feet max with 4 walls in between.
i have never done any wireless projects but envision a simple 2-button transmitter and a receiver which will momentarily short the same circuit that the button does when it is pressed. in a perfect world, the receiver would be powered by some circuitry already in the panel and the fob would be like a car alarm fob or a garage door opener type of transmitter.
Any help (including parts i actually would need [with weblinks]) is much appreciated.