Could some electronics guru here please clarify this ? Is it feasible to perform load pull simulation for a RF transistor using SPICE's transient(large signal) analysis scheme ? Of course the load or source has to be changed over a range of values, and for each run measure the RMS input output power ? Thanks in advance.
Steve Cripps used it for some purpose his RF Power Amplifiers book, and tau ght classes. (I took a class taught by him at Besser Associates in 1999-200
0 or so.) I haven't had much cause since 2003 to use his book, or material, so I don't remember the details. The book is now in its 2nd Ed. Highly rec ommended.Basic load-line matching gets you 95% of the way there -- to Popt at the lo ad-pull "football" center.
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.