Looking for 0.050" (1.27mm) Cable Mount Headers

I'm working on a design where the 0.1" standard IDC connectors are too large. So I thought of the 0.050" (127mm) connectors.

The thing is that I need some cable mount headers and these seem to only be available in 0.1".

Essentially I need this: in 0.05" spacing.

The closest I found was this: which would do even without the shroud, but I can't get a small quantity of them.

Reply to
sms
Loading thread data ...

Samtec and JST are my usual go-to manufacturers for fine pitch stuff but, of course, you'll probably want to poke around a bit.

Ribbon cable required? JST's PH and PHD are inexpensive and used in a lot of applications.

Reply to
Rich Webb

FCI?

I think 3M also has a series, but I dont recall then name at the moment.

Cheers

Reply to
Martin Riddle

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.