Do you have a question? Post it now! No Registration Necessary
September 3, 2005, 9:56 am
rate this thread
how easy/tricky is it to build a USB device that can control a motor speed?
Just a smal electric motor that needs to ramp between a few different RPMs,
no specific precision required..; just needs to be able to start/stop the
motor, and change its speeds to a few different preset levels ..
I'm presuming that driver interface would be the harder of the 2 parts of
dev (driver and hardware) .. What kind of hardware is best used to design a
circuit like this?
Any pointers for pre-made circuits like this?
Thanks in advance!
- » Remember me rabbiting about non acceptance of hotmail address?
- — Newest thread in » Electronics Down Under
- » Transformatorek sterujący klucze w zasilaczu ATX
- — The site's Newest Thread. Posted in » Electronics (Polish)