Do you have a question? Post it now! No Registration Necessary
October 7, 2005, 6:35 am
rate this thread
Hi All, i have this bloody unit in for repair with the following fault.
It had FU2 fuse blown.
Traced it back to the output board and found D7526 S/C.
Replaced but fault remained.Checked all components and all rest ok.This unit
has 2 boards with a fan in between.Regulation board is ok unit works with
output board disconnected.
I cannot find cause of this fuse blowing .Has anyone seen this before or has
- » programowanie w C - bardzo ogĂłlne pytanie o filozofi Ä. Arduino w roli programatora ...
- — The site's Newest Thread. Posted in » Electronics (Polish)